F 02U V02 008-01
The sensor is designed to measure linear movement, e.g. the stabilizer bar movement. The electronic is designed with a stainless steel magnetic shaft with Hall element. The Hall element is disposed between two magnets in association with a movable specially formed ferromagnetic part. This is used to control flux in the sensor in order to produce a linearly varying output voltage dependent on the position.
More InfoB 261 209 858-01
The LP 25 twin is a linear potentiometer which is designed to measure the relative position of two points, e.g. the gear position, throttle position or suspension movement and for use in electronic throttle control systems. Its operating mode is based on the linear tape potentiometer principle where the distance travelled between the moving ends to the wiper is proportional to the resistance between them.
More InfoConnector KPSE 6E8-33P-DN – F 02U V01 319-01
Connector KPTA 6E6-4P-C-DN – B 261 209 136-01
The LP 50 is a linear potentiometer which is designed to measure the relative position of two points, e.g. the gear position, throttle position or suspension movement. The operating mode of this sensor is based on the linear tape potentiometer principle where the distance travelled between the moving end to the wiper is proportional to the resistance between them. Variants available.
More InfoB 261 209 859-01
The LP 50 twin is a linear potentiometer which is designed to measure the relative position of two points, e.g. the gear position, throttle position or suspension movement and for use in electronic throttle control systems. It works base on the linear tape potentiometer principle where the distance travelled between the moving end to the wiper is proportional to the resistance between them.
More InfoConnector KPSE 6E8-33P-DN-A34 – B 261 209 852-01
Connector ASL 6-06-05PA-HE – B 261 209 856-01
The LP 75 is a linear potentiometer which is designed to measure the relative position of two points, e.g. the gear position, throttle position or suspension movement. The operating mode of this sensor is based on the linear tape potentiometer principle where the distance travelled between the moving end to the wiper is proportional to the resistance between them. Variants available.
More InfoConnector KPSE 6E8-33P-DN-A34 – B 261 209 853-01
Connector ASL 6-06-05PA-HE – B 261 209 857-01
The LP 100 is a linear potentiometer which is designed to measure the relative position of two points, e.g. the gear position, throttle position or suspension movement. Its operating mode is based on the linear tape potentiometer principle where the distance travelled between the moving end to the wiper is proportional to the resistance between them. Variants available.
More InfoF 02U V02 061-01
The sensor is designed to measure linear movement, e.g. the stabilizer bar movement. The electronic is designed with a stainless steel magnetic shaft with Hall element. The Hall element is disposed between two magnets in association with a movable specially formed ferromagnetic part. This is used to control flux in the sensor in order to produce a linearly varying output voltage dependent on the position.
More InfoB 261 209 534-01
The LP 150 is a linear potentiometer which is designed to measure the relative position of two points, e.g. the gear position, throttle position or suspension movement. Its operating mode is based on the linear tape potentiometer principle where the distance travelled between the moving end to the wiper is proportional to the resistance between them.
More Info